Frequently Asked Questions

What is Battery? How does it work?

First of all, it is necessary to give an electric current to the starter motor so that the vehicle can run at the first time. It is the device that chemically stores electrical energy to send current to the receivers that will be used when the vehicle engine is not running.

What are the battery types?

Batteries are divided into types according to the type of metal used. Today, the most widely used type of batteries are lead-acid accumulators. Lead-acid batteries are mainly divided into dry and juicy.

Why Battery Discharges?

Environmental and storage conditions
Short circuits in the vehicle
Lamps left open and etc.
Battery mismatch, small battery selection
Failure of the alternator to charge adequately

How to make the Battery Supplement?

Make sure that the battery you use for the connection is the same amperage.
Turn off the engine and everything that will be consuming electricity.
Firstly, the red end of the cable is discharged to the terminal (+) of the discharged battery; then connect the other end to the terminal of the charged battery.
Then connect the black end of the cable to the (-) terminal of the charged battery and the other end of the cable to any metal part on the discharged battery vehicle body.
Make sure that the cables do not come into contact with moving or hot spots such as exhaust, propeller.
Run the cordless vehicle full, then run the empty cordless tool.
Starting from the vehicle with empty battery powered vehicle after working; disconnect the cables.

How do the weather conditions affect the battery?

The freezing temperature of the fully charged battery is between 50 degrees Celsius and -70 degrees Celsius.

What are the installation steps of the battery?

The ignition is switched off.
Vehicle voltage and direction (reverse-flat battery) is controlled by voltmeter. (Do not reverse the vehicle as it will damage the vehicle's electronic system).
The negative (-) plus (+) terminal is removed before the battery to be replaced in the vehicle.
The vehicle battery tray and the cable ends are cleaned and the new battery is inserted and the lower connections are carefully tightened.
When connecting the new battery, first the positive (+) terminal and then the negative (-) terminal are connected and carefully tightened. Care should be taken not to damage the battery terminals while tightening.

Battery installation considerations

High heat damages the battery more than extreme cold. The best protection against extreme weather conditions is to keep your battery fully charged.
In addition, periodically checking the terminals (plus / minus poles) against oxidation and relaxation, and keeping your car in a closed garage during cold weather, especially at night, ensures maximum performance from your battery for a long time.
The most vibration caused by the batteries is encountered. Particular attention should be paid to the fact that the battery is mounted in such a way that the shock is not allowed and that the connections are tight.
Used batteries; from ear to ear with information; re-use for heating purposes and / or revitalization with other methods; may cause leakage, explosion or burns. It is definitely not recommended, as it can damage both your vehicle and more importantly damage you.

Considerations for correct use

The surface of the battery should be kept clean and dry.
It should be ensured that there is no loosening or oxidation in the battery connection points. If the battery type is suitable, the battery must be checked for water, and pure water should be added if there is a decrease. Absolutely no acid.
If the battery is stored for a long time, ensure that it is fully charged.